The construction process of PVC cabinet board: grid elastic line-blanking and pre-laying-gluing and pasting-seam welding-waxing treatment.

　　 First of all, it is the split line: the line is carefully stretched according to the room size and plastic board specifications. The size and shape of the basic grid should be determined according to the design pattern, room size and the specific size of the plastic board. When dividing the grid, consider reducing the number of welds as much as possible and taking into account the symmetry of the grid. If the area around the wall is not enough, it can be treated as a border. Bullet lines from the center of the room to the surrounding grids to ensure the symmetry of the grids. If the area around the wall is not enough, it can be treated as a border. Before pasting, it should be stretched on the ground according to the design grid size. The grid size should not exceed 90 cm. When springing the line around the room or at the base of the column, leave a width of not less than 12 cm. When pasting the plastic skirting board, trim it.

　　 Cutting and pre-laying: In order to facilitate adjustment, pre-laying must be done after cutting. The cutting should be carried out according to the actual size of the room floor division. When cutting, lay the soft PVC floor flat on the ground or operating platform, draw a cutting line on the board, and cut with a "V"-shaped slit cutter. The edge of the board should be cut into a smooth groove, and the angle of the groove and the opening of the two boards is about 55 degrees. The day before the soft PVC floor is formally pasted, it should be pre-laid according to the grid. When paving, try to take care of the same tone and the same thickness. The pre-paved panels shall not be moved and will be pasted the next day.

Gluing and pasting: Open the pre-paved soft PVC floor, pour 2/3 of the special adhesive on the base layer and the sticking surface of the soft plastic board, and then use a brush or a toothed bracket (not suitable Use a brush) to evenly scrape vertically and horizontally. After 3 to 4 minutes, apply the remaining 1/3 of the glue to the base layer and the sticking surface in the same way. After 5 to 6 minutes, align the periphery of the soft plastic board with the grid line of the base layer. After high-speed stitching to meet the requirements, pressure is applied to the back side. Then roll back and forth from the center of the board to the surroundings with a roller or use a special plastic bracket to push back and forth to exhaust all the air under the board to make the board surface and the base layer adhere tightly, and then discharge the sand bag for compaction. After each piece of paving, venting and squeezing the glue, wipe the glue on the edge of the ground to prevent the glue from drying out and affecting the accuracy of the jointing. For those with borders, the borders should be pasted first; for those without borders, they can be pasted from the innermost side of the room to the door to ensure that the pasted panels are not disturbed by pedestrians. After the soft PVC floor is pasted, the temperature of the construction site must be maintained at 10 to 30 degrees within 5 to 10 hours, and the ambient temperature should not exceed 70%. No one can walk around within 24 hours after pasting.

　　 Patchwork welding: Patchwork is an important means to ensure the flatness and integrity of the ground, so the welding must be full and satisfactory.

　　 Waxing treatment: Before handing over, wax the floor surface to increase the brightness of the floor. After the board seam is welded, the soft PVC floor can be waxed to improve its finish, decoration and effect.

If you are interested in UV print pvc board, welcome to your come and purchase!