First of all, let's introduce the heat press machine. The veneer hot press is suitable for neutral furniture factories or professional veneer factories. Hot press veneer, double veneer hot press, single veneer hot press, features: the hot press system heats up quickly, the heating system and the heat conduction system are lightly designed in sections, and the heat consumption is low and the heat conduction is uniform; the mechanism is located on the ground Reasonable, high precision of parts processing, wide adjustment range of process parameters, reasonable control process design, can meet the process requirements of various veneer production. It can be used for thermocompression bonding of furniture panels, building partitions, wooden doors and various man-made panels.
Veneer hot press

What are the common problems of veneer hot press?
1. Is it appropriate to use a veneer hot press for veneer veneer?
(1) For the veneer slab, the pressing speed should not be too fast, otherwise, the veneer cannot be stretched. However, the time from boosting to closing should not exceed 2 minutes to avoid problems such as pre-curing of the glue layer in the veneer. For each laminate, the thickness of the board cannot exceed 2 or 3 mm.
(2) If the glue thickness of the veneer is 0.2 to 0.3 mm, then in order to avoid cracks after being pressed by the veneer hot press, you can spray water or smear the surface of the veneer before the hot press A layer of formic acid bath, the solution concentration is 5%-10%. And pay attention to the periphery of veneer, which is prone to problems.

  1. On the veneer hot press, if the cylinder cannot be lifted after being lowered, what is the reason?
    On the veneer hot press, if the above problems occur, first check whether the solenoid valve is energized, and secondly, whether there is a stuck problem in the solenoid valve.

If you are interested in heat transfer foil, welcome to contact us!